User`s guide

10 – Performing Diagnostics
Setting the Diagnostic Test Parameters
10-6 FS0054603-00 C
Q
10.2
Setting the Diagnostic Test Parameters
Perform the following steps to set the loopback or read/write buffer test parameters:
1. From the SANsurfer FC HBA Manager main window HBA tree, select the HBA
port.
2. Click the Diagnostics tab. The Diagnostics tabbed page displays (see
figure 10-1).
Figure 10-1. Diagnostics Tabbed Page
The identifying information displays:
❑ Hostname. The name or IP address of the host connected to the HBA
❑ HBA Model. The QLA200/QLA2xxx HBA
❑ Port. HBA port number
❑ Node Name. World wide HBA node name
❑ Port Name. World wide HBA port name
❑ Port ID. Port ID of the HBA port
The diagnostic test parameters are in the Test Configuration section.