User`s guide

2 – Using SANbox Manager
Starting SANbox Manager
59022-05 A 2-7

Figure 2-2 Load Default Fabric View File Window
To start using the SANbox Manager application, do the following to add a fabric:
1. Open the Fabric menu and select Add Fabric to open the Add a New Fabric
window as shown in Figure 2-3.
Figure 2-3 Add a New Fabric Window
2. Enter a fabric name and the IP address of the switch through which to
manage the fabric.
3. Enter an account name and a password. The factory account name is
"admin" and the factory password is "password". If security is turned off
(default), you are not required to enter an account name or password. This
account name is for the switch and is stored in the switch firmware. Refer to
the User Command on page A-69 for more information.
4. Choose the Add Fabric button.