User`s guide

A – Command Line Interface
Show Log Command
59022-05 A A-57

Show Log Command
Displays the contents of the log or the parameters used to create entries in the
log. The log contains a maximum of 200 entries. When the log reaches its entry
capacity, subsequent entries overwrite the existing entries, beginning with the
oldest.
Authority User
Syntax show log
component
level
options
port
settings
Keywords component
Displays the components currently being monitored for events.
level
Displays the event severity level needed to create an entry in the log. If the
severity level occurs on a port or on a component which is not defined, no entry is
made in the log.
options
Displays the options used to set the component and log level attributes.
port
Displays the ports being monitored for events. If an event occurs which is of the
defined level and on a defined component, but not on a defined port, no entry is
made in the log.
settings
Displays the current settings for component, level and port. This command is
equivalent to executing the following commands separately: Show Log
Component, Show Log Level, and Show Log Port.
Examples The following is an example of the Show Log Component command:
SANbox2 #> show log component
Current setting(s) for log component: NameServer
The following is an example of the Show Log Level command:
SANbox2 #> show log level
Current setting(s) for log level: Info