User`s guide

3 – Alarm Messages
Alarm Messages
3-18 PRELIMINARY 59060-00 01
0
[A1005.000C] [nserver] [Requested credit not granted for port % d, donors at time, %s]
Meaning: Insufficient credits were available in the credit pool to grant the
credit request.
Action: Decrease the number of requested credits or add more donor
ports.
[A1005.000D] [nserver] [Insufficient extended credit pool error, no credit granted for port:
<port>]
Meaning: Insufficient credits were available in the credit pool to grant the
credit request.
Action: Decrease the number of requested credits or add more donor
ports.
[A1005.000E] [nserver] [Can't extend credit on loop capable ports]
Meaning: Loop ports cannot borrow credits from the credit pool.
Action: Change the port type to G_Port or F_Port.
[A1005.0012] [Port] [Loop device <al_pa> did not take OPN off loop, removing it from
nameserver.]
Meaning: The named loop device failed or has been removed.
Action: Reinstall or replace the device.
[A1005.0013] [SM] [Hot-swap had failed before last reset - MUST power cycle switch]
Meaning: The I/O blade hot-swap procedure failed and the switch was reset
instead of power cycled.
Action: Power cycle the switch.
[A1005.0013] [SM] [Hot-swap procedure failed - MUST power cycle switch]
Meaning: The blade hot-swap procedure failed or the procedure was not
followed correctly.
Action: Power cycle the switch.
[A1005.0013] [SM] [Hot-swap procedure never completed - MUST power cycle switch]
Meaning: The I/O blade hot-swap procedure was not completed.
Action: Power cycle the switch.
[A1005.0014] [SM] [Retrying port <port> that was DISABLED due to excessive errors]
Meaning: The switch is attempting to bring a port online that was previously
disabled due to excessive errors.
Action: None