User`s guide

3 – Alarm Messages
Alarm Messages
59060-00 01 PRELIMINARY 3-11
0
[A1004.0011] [Eport] [Eport Isolating due to Remote switch Isolated]
Meaning: An E_Port isolated because the remote switch has the same
domain ID.
Action: Change the domain ID on one of the switches.
[A1004.0013] [Eport] [Eport Isolating due to No Principal Present]
Meaning: An E_Port isolated because the principal priority on all switches is
set to 254.
Action: Configure one of the switches to be the principal switch by
changing the principal priority.
[A1004.0014] [Eport] [Eport Isolating due RDI ELP TOV Mismatch]
Meaning: An E_Port isolated because the R_A_TOV or E_D_TOV time out
values are different on the two switches.
Action: Modify the switch configurations so that R_A_TOV or E_D_TOV
values are the same.
[A1004.0017] [Eport] [Interop credit change, resetting port.]
Meaning: The number of interoperability credits has been changed on a port
and the port is reinitializing.
Action: None
[A1004.0018] [Eport] [InteropCredit configured at <credits>, <credits> BB Credits
available. Configure ExtCredit to increase.]
Meaning: The number of interoperability credits is set higher than the
available number of port buffer credits.
Action: Extend credits on this port to match or exceed the number of
interoperability credits.
[A1004.0019] [Eport] [Link unstable. Link init will be held back until link up time is 5
seconds]
Meaning: An ISL has become unstable as a result of a state change. The
switch will delay reinitializing the E_Port by 5 seconds to allow the
link to stabilize.
Action: None
[A1004.001A] [Eport] [ELP indicates E-Port command not supported on remote port,
Isolating]
Meaning: An E_Port isolated because the port on the remote switch could
not configure itself as an E_Port.
Action: Change the port type on the remote switch to G_Port or GL_Port.