Installation guide

B – Command Line Interface
Show Command
59043-01 B B-49
Q
LIP_AL_PD_AL_PS Number of F7, AL_PS LIPs, or AL_PD (vendor specific)
resets, performed.
LIP_F7_AL_PS This LIP is used to reinitialize the loop. An L_port, identified
by AL_PS, may have noticed a performance degradation and
is trying to restore the loop.
LIP_F8_AL_PS This LIP denotes a loop failure detected by the L_port
identified by AL_PS.
LIP_F7_F7 A loop initialization primitive frame used to acquire a valid
AL_PA.
LIP_F8_F7 A loop initialization primitive frame used to indicate that a loop
failure has been detected at the receiver.
Link Failures Number of optical link failures detected by this port. A link
failure is a loss of synchronization for a period of time greater
than the value of R_T_TOV or by loss of signal while not in
the offline state. A loss of signal causes the switch to attempt
to re-establish the link. If the link is not re-established by the
time specified by R_T_TOV, a link failure is counted. A link
reset is performed after a link failure.
Login Time when the port logged in.
Logout Time when port logged out.
LoopTimeouts A two (2) second timeout as specified by FC-AL-2.
LossOfSync Number of synchronization losses (>100 ms) detected by this
port. A loss of synchronization is detected by receipt of an
invalid transmission word.
PrimSeqErrors Primitive sequence errors detected.
RxLinkResets Number of link reset primitives received from an attached
device.
RxOfflineSeq Number of offline sequences received. An OLS is issued for
link initialization, a Receive & Recognize Not_Operational
(NOS) state, or to enter the offline state.
TotalErrors Total number of errors detected.
TotalLIPsRecvd Number of loop initialization primitive frames received by this
port.
TotalLinkResets Total number of link reset primatives.
Table B-13. Show Port Parameters (Continued)
Entry Description