Installation guide

B – Command Line Interface
Set Setup Command
59043-01 B B-43
Q
system
Prompts you in a line-by-line fashion to change system configuration settings.
Table B-12 describes the system configuration fields. For each parameter, enter a
new value or press the Enter key to accept the current value shown in brackets.
TrapCommunity Trap community password that authorizes an SNMP agent to
receive traps. This is a write-only field. The value on the switch
and the SNMP management server must be the same. The
default is “public”.
AuthFailureTrap Enables (True) or disables (False) the generation of traps in
response to trap authentication failures. The default is False.
ProxyEnabled Enables (True) or disables (False) SNMP communication with
other switches in the fabric. The default is True.
Table B-12. System Configuration Settings
Entry Description
Eth0NetworkDiscovery Boot Method (1 - Static, 2 - Bootp, 3 - DHCP, 4 -
RARP)
Eth0NetworkAddress Internet Protocol (IP) address for the Ethernet port.
Eth0NetworkMask Subnet mask address for the Ethernet port.
Eth0GatewayAddress IP address gateway.
AdminTimeout Specifies the amount of time in minutes the switch
waits before terminating an idle Admin session. Zero
(0) disables the time out threshold. The default is 30,
the maximum is 1440.
SecurityEnabled Enables (True) or disables (False) the enforcement of
account names and passwords. The default is False.
LocalLogEnabled Enables (True) or disables (False) the saving of log
information on the switch. The default is True.
RemoteLogEnabled Enables (True) or disables (False) the recording of
the switch event log on a remote host that supports
the syslog protocol. The default is False.
RemoteLogHostAddress The IP address of the host that will receive the switch
event log information if remote logging is enabled.
The default is 10.0.0.254.
Table B-11. SNMP Configuration Settings
Entry Description