Installation guide

B – Command Line Interface
Set Config Command
59043-01 B B-29
Q
ISLSecurity E_Port security. Determines which
switches a port will establish a link with.
 Any - link with any FC-SW-2 compliant
switch.
 Ours - link only with an FC-SW-2
compliant QLogic switch.
 None - reject the link.
SymbolicPortName Descriptive name
ALFairness Arbitration loop fairness. Enables (True) or
disables (False) the switch’s priority to
arbitrate on the loop.
DeviceScanEnabled Enables (True) or disables (False) the
scanning of the connected device for FC-4
descriptor information during login. The
default is True.
ForceOfflineRSCN Enables (False) or disables (True) the
immediate transmission of RSCN
messages when communication between
a port and its device is interrupted. If
enabled, the RSCN message is queued
for 200 ms. The default is False. This
parameter is ignored if IOStreamGuard is
enabled.
ARB_FF Use ARB_FF instead of idles on loop
FCAL option
InteropCredit Interoperability credit. The number of
buffer-to-buffer credits per port. 0 means
the default (12) is unchanged.
ExtCredit Extended credits. The number of port
buffer credits that this port can acquire
from donor ports.
FANEnable Fabric address notification. Enables (True)
or disables (False) the communication of
the FL_Port address, port name, and node
name to the logged-in NL_Port.
LCFEnable Link control frame preference, R_CTL =
0xC
MFS_TOV MFS limit for camp on
Table B-7. Set Config Port Parameters (Continued)
Parameter Description