Installation guide

B – Command Line Interface
Fallback Command
B-10 59043-01 B
Q
Fallback Command
Loads the fallback version of the firmware from switch memory. The switch stores
two versions of the firmware. This command alternately activates the two
versions.
Authority Admin
Syntax fallback
Notes  The Show Switch command displays the available firmware versions and
the currently active version.
 After executing the Fallback command, reset the switch for the firmware to
be placed in effect.
Examples The following is an example of the Fallback command:
SANbox2 #> admin start
SANbox2 (admin) #> fallback
Reverting to previous software image. Please confirm (y/n): [n] y
SANbox2 #> admin end