User`s guide

5
Known Issues with McData/SANbox2 operation:
The McData switch does not support Port and FC Address zoning. Their use on
the SANbox2 switch should be avoided, if connected to a McData switch.
As with the Brocade switch, orphan visibility should be off. Do this by using the
CLIsh command “set config zoning” to set “Default” to “None”.
Problems corrected in this release
Problem
No.
Description
4654
There are JBODs that do not send a LIP when a drive is removed. This causes the name server
entries to remain in the table.
5142
After an ISL cable pull, the GA_NXT is rejected when port 0 is an F_Port and the driver requests
port_address - 1.
5164
Commands that require admin mode to be executed, when executed in a regular user mode, don't
display any error messages.
5314
Overnight run of offline/online ports with HDS 9960 caused buf mem to be exhausted.
5323
After moving an F_Port from port 6 to port 7, the green port light stayed on and the same WWN
showed up for port 6 and port 7 in the name server.
5325
ELP WWN comparisons Standards changed. Use ELP switch WWN instead of port.
5330
Send only the Domain level RSCN when the remote switch powers up. The local switch will filter out
any Port or Area RSCN for devices on the remote switch.
5444
Finisar 2Gb SFPs, model number FTRJ-8519-7D-2.5, support a DC restore loop mechanism that
takes over when there is no traffic on the wire for more than a few milliseconds. The POLT offline
tests were not allowing time for loop stabilization to complete after this mechanism takes over.
5500 In setting E_ports online and offline and stopping that by using ^C, a random Eport will be in a state where
it is sending SW_RJT frames to the other E_port. In order to recover from this, you must reset the
switches.
6069 After 25-28 days, the ports do not respond if the connected device is rebooted.