Installation guide

5
Problems corrected in 1.5.1
Problem
No.
Description
5949 There are some situations where multiple SNMP change traps are being sent when their values have not
changed.
6255 TL does not work in conjunction with VPF hard zoning. For example, if you have zones, one containing all
TL-port devices and a second containing all GL-ports, zoned by domain/port, all will work until the zone
with the GL-ports is set to be a VPF zone. The TL-port devices can no longer access each other. To
recover, change the zones to soft zones.
6261 Set a FL port to diagnostic state, then offline/online. Unplug the device and the LED stays on. Replug the
FL port, the FL port cannot log back into the same port. To recover, reset the port.
6299 When unplugging cable from host, switch port LED remains on and name server still thinks the host is still
connected. This is an intermittent problem. To recover, plug/unplug the cable.
6323 If you change port speed from auto-negotiate to 2Gb fixed, plug in a 2Gb JBOD, the port will not log in.
You can recover by setting the port to auto-negotiate and resetting the port.
6353 When using a 2Gb JBOD, if you fix the port speed at 2Gb and change the port type from FL to GL, the port
will not log in and the LED will flash. This can be avoided by using auto negotiation speed instead of fixed
speed. You can recover from this by resetting the port.
6361 With either a TL or FL port, if you transition from auto negotiation speed to 2Gb fixed speed and then
unplug the cable, the LED will stay on. You can recover from this by resetting the port.