Installation guide

3
Installing the Firmware via telnet
The following procedure should be used, to download Version 1.5.1.04:
After downloading new firmware from QLogic, change directory to the directory
where the new firmware is located.
ftp to the switch
login using username images, password images
enter the following commands:
> bin
> put fullimage.XXX (where XXX represents the version of the firmware)
> quit
telnet to the switch
login using username: admin, password: password
enter the following commands:
> admin start
> image unpack fullimage.XXX
reset the switch (resetting switch will disrupt traffic)