User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index
Preliminary
Multistage Topology
SANbox-8 Fibre Channel Switch
5-20 Multi-Chassis Fabrics 59008-03 Rev. A Installer’s/User’s Manual
Multistage Examples
Figures 5-3 through 5-5 are examples of Multistage topology using SANbox-8
Switch chassis.
Figure 5-3 SANbox-8 Multistage with one T_Port link from each IO/T chassis
Figure 5-3 shows a Multistage Switch built from SANbox-8 chassis. Each of the
eight IO/T chassis has one T_Port connection (the minimum) to the CC chassis.
This provides 100 MBytes of bandwidth between each IO/T chassis and no
failover in case a T_Port fails. Note that any IO/T chassis can communicate with
any other IO/T chassis with just three chassis hops (counting the source and desti-
nation chassis.
There are seven user ports remaining on each IO/T chassis. All user ports may be F,
FL, SL, or TL_Ports.
If you used a SANbox-16 as a Cross-Connect, you could expand this configuration
to 16 IO/T chassis.