User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index
Preliminary
Cascade Topology
SANbox-8 Fibre Channel Switch
5-14 Multi-Chassis Fabrics 59008-03 Rev. A Installer’s/User’s Manual
Cascade Zoning
Sanbox Switch chassis support fabric-wide zones for all zone types. Broadcast
zones and Name Server zones require no special consideration in a cascade fabric.
That is, you may assign these zones on a user-port-by-user-port basis and T_Ports
are not zoned.
Hard Zones, however, require zoned T_Port interconnections between chassis
which contain ports in the same Hard Zone. That is, if a particular Hard Zone is
distributed across chassis boundaries, each piece of that Hard Zone and its inter-
connecting T_Ports must be assigned to the same Hard Zone number. This makes
interconnections between pieces of the same Hard Zone much like the interconnec-
tion of chassis.
MKII Compatibility
SANbox fabrics do not support MKII chassis in cascade topologies.
NOTE:
Also, remember that mixing of topologies is not allowed. If the fabric topology
is Cascade, then the interconnection of the Hard Zones must also be accom-
plished in Cascade topology.