User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index
Preliminary
Input Fuse
SANbox-8 Fibre Channel Switch
Installer’s/User’s Manual 59008-03 Rev. A Removal/Replacement Procedures 4-3
Replacement
1. Insert the Fuse(s) into the Fuse Board. Refer to Appendix A Reference Infor-
mation for fuse-type information.
2. Insert the Fuse Board into the Fuse holder and press it in until it clicks past
the Latch.
3. Insert the Fuse Holder into the AC Power Plug Assembly and press it in until
it is flush with the front surface of the assembly.
4. Plug the AC Power Cable into the AC Power Plug Assembly.
5. Press the Power Switch to the ON (1) position.