User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index
Preliminary
Input Fuse
SANbox-8 Fibre Channel Switch
4-2 Removal/Replacement Procedures 59008-03 Rev. A Installer’s/User’s Manual
Input Fuse
Removal
1. Press the Power Switch to the OFF (0) position.
2. Unplug the AC Power Cable from the front of the Switch chassis.
3. Refer to Figure 4-1. Insert a thin-blade screwdriver into the slot behind the
tab and twist it to pull the Fuse Holder out the front of the AC Power Plug
Assembly.
4. Lift the latch on the Fuse Holder until you can withdraw the Fuse Board.
5. Pull the Fuse(s) from the Fuse Board.
Figure 4-1 Removing the Input Fuse
AC Power Plug
Assembly
Slot
Fuse Holder
Fuses (2)
2 AMP, 250V
Fuse Board
Latch
Tab