User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index
Preliminary
SANbox-8 Fibre Channel Switch
vi
59008-03 Rev. A Installer’s/User’s Manual
Mesh Zoning 5-17
MKII Compatibility 5-17
Multistage Topology 5-18
T_Port Rules for SANbox IO/T Chassis 5-18
T_Port Rules for SANbox Cross-Connect (CC) Chassis 5-18
Multistage Fabric Size 5-18
Multistage Latency 5-18
Multistage Bandwidth 5-19
Multistage Physical Distance Between Chassis 5-19
Multistage Zoning 5-19
MKII Compatibility 5-19
Multistage Examples 5-20
Cabling 5-23
Fiber Optic T_Port Connections 5-23
Copper T_Port Connections 5-23
T_Port Cable Length 5-23
Device Connections 5-23
Chassis Configuration 5-24
Chassis Configuration Process 5-25
A
Reference Information
QLogic Customer Support A-1
SANbox-8 Switch Specifications A-2
Switch A-2
Shortwave Laser GBIC (multi-mode) A-5
Longwave Laser GBIC (single-mode) A-6
Copper Inter-Enclosure GBIC (active) A-6
Copper Intra-Enclosure GBIC (passive) A-7
B
QLogic Customer Support
Help Desk B-1
Hardware Support B-1
Software Support B-2
Customer Responsibilities B-2
Index