User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index
Preliminary
Cable Fibre Channel Devices to the Switch
SANbox-8 Fibre Channel Switch
Installer’s/User’s Manual 59008-03 Rev. A Installation 2-13
Variety of Public Device Connections
Figure 2-5 shows a variety of Public device connections.
Figure 2-5 Variety of Public Connections
Rx
Tx
Rx
Tx
Rx
Tx
RxTx
1
Rx
Tx
2
3 5
6
7
8
Tx
Rx
Tx
Rx
Tx
Rx
FL_Port
Tx
Rx
Tx
Rx
F_Port
4
Tx
Rx
F_Port
F_Port
F_Port
Tx
Rx
F_Port
FL_Port
FL_Port
Tx
Rx
Rx
Tx
Rx
Tx
Tx
Rx
Tx
Rx
Tx
Rx
Tx
Rx
Tx
Rx
Tx
Rx
Tx
Rx
Public Loop
Tape
Backup
Public FC to
SCSI Bridge
Controller #1
JBOD
RAID
Public Loop
Controller #2
Public FC
Hub
Public Loop Devices
Public Loop
Devices
Public Storage
Server