User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index
Preliminary
Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
SANbox-8 Fibre Channel Switch
Installer’s/User’s Manual 59008-03 Rev. A Installation 2-3
Figure 2-1 Cabinet Mounting Bracket
Apply the IEC Class 1 Laser Information Label (If the installation is in
Europe)
Refer to Figure 2-2. When a Switch using fiber optic GBICs is installed at a site in
Europe, IEC regulations require that you install a Class 1 laser information label
placed where it is clearly visible whenever access to the optical ports is possible.
Figure 2-2 IEC Class 1 Laser Information Label
Remove the paper on the back of the label and apply it to the equipment rack.
CLASS 1 LASER PRODUCT
TO IEC 825 (1984) + CENELEC HD 482 S1
LASER KLASSE 1
LUOKAN 1 LASERLAITE
APPAREIL A LASER DE CLASSE 1