User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index
Preliminary
AC Input Power Connector and Fuses
SANbox-8 Fibre Channel Switch
1-22 General Description 59008-03 Rev. A Installer’s/User’s Manual
AC Input Power Connector and Fuses
Refer to Figure 1-5. A standard 3-wire computer-type AC power cable (supplied
with the Switch) connects between the AC Input Power Connector and an AC
outlet. Refer to “Switch Electrical” on page A-4 for the AC Power Requirements.
See also Section 2 Installation for installation procedures.
An Input Fuse Holder is incorporated into the AC Input Power Connector
assembly. It holds two input fuses. Refer to “Input Fuse” on page 4-2 for fuse
removal and replacement procedures and to “Switch Electrical” on page A-4 for
fuse size.
Switch Management Connector
Refer to Figure 1-5. The Switch Management Connector is a 10/100BASE-T
Ethernet interface that provides a connection to a management station. Refer to the
Switch Management manual for information about how to connect the manage-
ment station and manage the Switch.
Ethernet LEDs
LINK Status
Refer to Figure 1-5. The green LINK Status LED lights only when the Ethernet
Interface establishes an electronic link.
Activity
The yellow Activity LED lights when the interface is transmitting data to the
network or receiving data from the network.