User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index
Preliminary
SANbox-8 Fibre Channel Switch
iv
59008-03 Rev. A Installer’s/User’s Manual
Power Switch 1-19
Test Mode Switch 1-19
Front Panel LEDs 1-20
Heartbeat LED (Yellow) 1-20
Switch Logic Power Good LED (Green) 1-20
Fan Fail LED (RED) 1-20
Over Temperature LED (Red) 1-20
Logged-In LED (Green) 1-21
Traffic LED (Yellow) 1-21
AC Input Power Connector and Fuses 1-22
Switch Management Connector 1-22
Ethernet LEDs 1-22
LINK Status 1-22
Activity 1-22
2
Installation
Introduction 2-1
Unpack 2-1
Place or Mount the Equipment 2-2
Shelf Mount 2-2
Rack Mount 2-2
Apply the IEC Class 1 Laser Information Label (If the installation is in Europe) 2-3
Install GBICs 2-4
Connect to AC Power 2-4
Switch Logic Power Good LED 2-6
Check the Power-On-Self-Test (POST) Results 2-6
Cable Fibre Channel Devices to the Switch 2-7
Public Devices 2-7
Private Devices 2-8
Mixing Public and Private Devices on the Same Loop. 2-8
Switch Ports 2-8
Tuning 2-8
Distance 2-9
Port Buffer Credits 2-9
Hot-Pluggable 2-10
Incorrect Cabling 2-10
Connections 2-10
Examples 2-11
Configure the Chassis 2-16
Configure the Ports 2-17
Fabric Ports 2-17
SL_Ports 2-17