User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index
Preliminary
Fibre Channel Ports
SANbox-8 Fibre Channel Switch
Installer’s/User’s Manual 59008-03 Rev. A General Description 1-17
Fibre Channel Ports
Figure 1-5 identifies the parts of the chassis front. Port numbers are marked on the
front of the chassis. Notice that the order of transmit (TX) and receive (RX)
connectors on the bottom row of ports is reverse of that on the top row. Also notice
that the relative position of the Traffic and Logged-In LEDs is reversed between the
bottom and top rows of ports.
Figure 1-5 Chassis Front
8
3
RxTx
1
Rx
Tx
2
3
4
5
6
7
8
Switch Logic Power
Good LED (Green)
Fan Fail LED
(Red)
Over Temperature LED
(Red)
Heartbeat LED
(Yellow)
Port
Number
Traffic LED
(Yellow)
Logged-In LED
(Green)
RX TX
Power
Switch
AC Power Plug
Input Fuses
Rack Mounting
Brackets (2)
Activity LED
(Ethernet)
Link Status LED
(Ethernet)
Switch Management
Connector (RJ45)
Port Number
Traffic LED
(Yellow)
Logged-In LED
(Green)
Test Mode Switch
RX
TX