User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index
Preliminary
Major Switch Management Features
SANbox-8 Fibre Channel Switch
1-14 General Description 59008-03 Rev. A Installer’s/User’s Manual
• Configure the translation entries list for TL_Ports and control the TL_Port
Auto Learning feature
• Archive all configurable chassis parameters for all the chassis in a fabric
• Restore all configurable chassis parameters for all chassis in a fabric by using
the archived configuration