User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index
Preliminary
SANbox-8 Fibre Channel Switch
Installer’s/User’s Manual 59008-03 Rev. A
iii
Table of Contents
Preface
How to Use This Manual 1
Intended Audience 1
Related Materials 2
Safety Notices 3
Sicherheitshinweise 3
Notes informatives relatives à la sécurité 3
Communications Statements 4
Federal Communications Commission (FCC) Class A Statement 4
Canadian Department of Communications Class A Compliance Statement 4
Avis de conformité aux normes du ministère des Communications du Canada 4
CE Statement 5
VCCI Class A Statement 6
Laser Safety Information 7
Labeling Requirements 7
Accessible Parts 8
Pièces Accessibles 8
Zugängliche Teile 8
QLogic Customer Support 9
1
General Description
Introduction 1-1
Major Fibre Channel Port Features 1-2
Fabric Port Overview 1-3
Segmented Loop Port (SL_Port) Overview 1-3
Translated Loop Port (TL_Port) Overview 1-5
Major Switch Chassis Features 1-10
Major Switch Management Features 1-11
Switch Management Tools 1-15
SANsurfer Switch Management Application 1-15
Telnet 1-15
Trivial File Transfer Protocol (TFTP) 1-16
Simple Network Management Protocol (SNMP) 1-16
Fibre Channel Ports 1-17
GigaBit Interface Converters (GBICs) 1-18
Front Panel Controls 1-19