User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index
Preliminary
Major Fibre Channel Port Features
SANbox-8 Fibre Channel Switch
Installer’s/User’s Manual 59008-03 Rev. A General Description 1-9
• The user may disable the Auto Learning feature for any TL_Port. The default
for each TL_Port is Auto Learning enabled.
• The user may manage the translation entries list for any TL_Port connected
to Private initiators. That is, the user may identify all off-loop targets for the
initiators on the particular TL_Port. Auto Learning should be disabled for
these TL_Ports.
• SANsurfer provides a map of all AL_PAs on a Translated Loop. This
viewable map includes information about which AL_PA addresses are being
used by the TL_Port.
• SANsurfer provides a way to flag error conditions to the user.
• All Switch management configuration information is stored in non-volatile
memory.
• The user may clear the stored configuration information.