User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index

Preliminary
Index
SANbox-8 Fibre Channel Switch
Installer’s/User’s Manual 59008-03 Rev. A Index 5
translation entries list 1-7, 2-18
zoning 1-8
topology
cascade 5-11
choosing 5-9
mesh 5-15
multistage 5-18
Traffic LED 1-21
translated loop example 2-15
Translated Port - See TL_Port.
translation 1-6
transmission ranges A-3
Trivial File Transfer Protocol 1-16
troubleshooting
cable continuity 3-8
power supply 3-1
Trunk Port - See T_Port.
tuning ports 2-19
U
unpack 2-1
user interface A-3
V
VCCI - See Voluntary Control Council for Interference.
vibration A-4
voltage
fluctuations A-5
operating A-4
Voluntary Control Council For Interference 1-6
W
warning notice 1-3
world wide name 1-12, 2-20, 5-10, 5-26
WWN - See World Wide Name
Z
zone
broadcast 1-12, 2-21
hard 1-12, 2-20
Name Server 1-12, 2-20
segmented loop 1-13, 2-17, 2-20
zoning
cascade 5-14
description 2-20
mesh 5-17
multistage 5-10, 5-19
port 2-19