User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index
Preliminary
SANbox-8 Switch Specifications
SANbox-8 Fibre Channel Switch
Installer’s/User’s Manual 59008-03 Rev. A Reference Information A-7
Copper Intra-Enclosure GBIC (passive)
Connector:..........................................Style 1 (9 pin D-subminiature, DB-9)
Style 2 (HSSDC, looks like wide phone jack
or RJ45)
Cable:.................................................Fibre Channel 100-TW-EL-S (shielded dual
parallel pair cable)
Fibre Channel 100-TP-EL-S (shielded dual
twisted pair cable)
Differential Impedance: .....................150 ohms +/- 10 ohms
Transmitted Signal:............................600 - 2000 mV differential PECL
Received Signal: ................................400 - 2000 mV differential PECL
Distance: ............................................0 - 11 meters with 100-TP-EL-S cable
0 - 13 meters with 100-TW-EL-S cable