User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index

Preliminary
SANbox-8 Fibre Channel Switch
2
Preface 59008-03 Rev. A Installer’s/User’s Manual
Related Materials
The following manuals and materials are referenced in the text and/or provide
additional information.
• Switch Management Installer’s/User’s Manual, Publication Number 59010.
Available from QLogic Corporation.
• Fibre Channel-Arbitrated Loop (FC-AL-2) Rev. 6.8
• Fibre Channel-Private Loop SCSI Direct Attach (FC-PLDA)
NCITS TR-19:1998
• Fibre Channel-10-bit Interface Rev. 2.3
• Definitions of Managed Objects for the Fabric Element in Fibre Channel
Standard (draft-ietf-ipfc-fabric-element-mib-04.txt).
The Fibre Channel Standards are available from:
Global Engineering Documents, 15 Inverness Way East, Englewood, CO
80112-5776 Phone: (800) 854-7179 or (303) 397-7956
Fax: (303) 397-2740