User`s guide

4 – Installation
SANbox 6142 Router Installation
4-4 FI0054601-00 C
S
Pre-installation Check List
During the initial configuration process, the system prompts you for the
parameters listed in Table 4-2. Fill out the table before installation to expedite the
configuration process.
Mount the Router
You can place the router on a flat surface or mount it in a standard 19-inch
Electronic Industries Association (EIA) rack. See the product specification for
weight and dimensions. Rack mounting requires a QLogic rack mounting kit (Part
No. ISR614X-RACKKIT). Contact QLogic for more information.
If you mount the router in a closed or multi-unit rack assembly, make sure that the
operating temperature inside the rack enclosure does not exceed the maximum
rated ambient temperature for the router.
Table 4-2. Pre-installation Checklist
Symbolic name of this router
Management port IP address
(if not using DHCP)
Management port subnet mask (if not
using DHCP)
Management port gateway IP address (if
not using DHCP)
iSCSI Port 1 (GE-1) IP address
iSCSI Port 1 (GE-1) subnet mask
iSCSI Port 1 (GE-1) gateway IP address
iSCSI Port 1 (GE-1) iSNS
a
IP address
a
Internet Storage Name Service
iSCSI Port 2 (GE-2) IP address
iSCSI Port 2 (GE-2) subnet mask
iSCSI Port 2 (GE-2) gateway IP address
iSCSI Port 2 (GE-2) iSNS IP address