User`s guide

C – Configuring CHAP
Configuring CHAP Using CLI
C-2 FI0054601-00 C
S
a. Click General.
b. Click Secret (in the middle of the screen). If this is the first time you are
setting secrets, reset all secrets.
c. Type the secret (secret_port) that you created in Step 1.
4. Click Discovery.
5. Click Add.
6. Type the address of the iSCSI port of the router.
7. Click Advanced.
8. Select Chap Login Information.
9. Type the secret (secret_initiator) you created in Step 2 into Target Secret.
10. Select Mutual Authentication.
11. Click OK.
12. Click OK. The initiator completes the discovery.
CLI—Discovery Session—Uni-directional CHAP
To configure a single-direction CHAP used during a discovery session:
1. Do not enable CHAP on the ISCSI port.
2. Use Initiator add:
a. Add the initiator that is about to perform the discovery.
b. Enable the CHAP for this initiator.
c. Create a secret (for example, secret_initiator).
d. Use Set Chap to update the initiator’s CHAP settings.
3. Go to the MS Initiator.
4. Click Discovery.
5. Click Add.
6. Type the address of the iSCSI port of the router.
7. Click Advanced.
8. Select Chap Login Information.
9. In Target Secret, type the secret (secret_initiator) you created in Step 2.
10. Click OK.
11. Click OK. The initiator should complete discovery.