User`s guide

A – Command Reference
Commands
FI0054601-00 C A-11
A
Remote IPv6 Address [:: ]
fe80::21b:21ff:fe06:d517
MTU Size (0=Normal, 1=Jumbo, 2=Other) [Normal ]
TCP Window Size (0=8KB, 1=16KB, 2=32KB) [32768 ]
Window Scaling (0=Enable, 1=Disable) [Disabled ]
TCP Port No. (Min=1024, Max=65535) [3225 ]
GE Port Speed (0=Auto, 1=100Mb, 2=1Gb) [Auto ]
FCIP Time Stamp (0=Enable, 1=Disable) [Enabled ]
Resource Allocate TimeOut (Min=1sec, Max=5sec)[1 ]
Bandwidth, Mbit/sec (Min=1, Max=1000) [1000 ]
VLAN (0=Enable, 1=Disable) [Disabled ]
FCIP SW Compression (0=Enable, 1=Disable) [Disabled ]
All attribute values for FCIP Route 1 will now be saved.
FCIP route modify command example:
QRouter (admin) #> fciproute mod
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current
value. If you wish to terminate this process before reaching the end
of the list press 'q' or 'Q' and the ENTER key to do so.
WARNING:
The following command might cause a loss of connections to both GE
ports.
Route FC Port ID GE Port ID
----- ---------- ----------
1 FC1 GE1
Please select a FCIP route from the list above ('q' to quit): 1
Configuring FCIP Route: 1
---------------------------
FCIP Interfaces FC & GE (0=Enable, 1=Disable) [Enabled ]
IP Address (IPv4 or IPv6; 0=IPv6 Link Local) [:: ]
Selected IPv6 Link Local Address: fe80::2c0:ddff:fe0c:8be2
Remote IPv6 Address [fe80::21b:21ff:fe06:d517]
fe80::21b:21ff:fe06:d514
MTU Size (0=Normal, 1=Jumbo, 2=Other) [Normal ]