User`s guide

Table Of Contents
7 – SANsurfer iSCSI/FC Router Manager
Wizards
7-88 FI0054601-00 C
S
The Local and Remote IP Address dialog box requests entry of IP
addresses (see Figure 7-90).
Figure 7-90 FCIP Route Add WizardLocal and Remote IP Address Dialog Box
5. Configure any of the following parameters:
Local IP Address Enter the IP address the GigE port will use. An
uninitialized port has an IP address of all zeros.
Subnet Mask – Enter the subnet mask the GigE port will use.
Gateway IP Address – Enter the gateway IP address the GigE port
will use.
Remote IP AddressEnter the IP address of the GigE port the GigE
port will use on the remote router.
6. After setting the IP address parameters, click Next to continue or click
Cancel to quit the wizard.