User`s guide

7 – SANsurfer iSCSI/FC Router Manager
System Tree Window
7-24 FI0054601-00 C
S
Information Tab
The Information tabbed page consists of three areas: Port Information, iSCSI Port
Network Settings, and iSNS. The following paragraphs describe the information
displayed in these sections.
iSCSI Port Information
The iSCSI Port Information area provides the following parameters:
 Base Name – Displays the full name assigned to the selected iSCSI port.
 Link Status – Identifies the port connection status: Link Up or Link
Down.
 MAC Address – Displays the MAC address assigned to the port. The MAC
address is not changeable.
 Actual Link Rate – Displays the actual link rate, which can be Unknown,
1000 Mbps, 100 Mbps, or 10 Mbps. If the port's configuration or
connection has changed, the status may not be current. Click the Refresh
icon to display the current status.
 Programmed Link Rate – The configured data rate for the port. To
configure the data rate, open the drop-down menu and select one of the
following data rates:
 Auto - Data rate determined by network attachment
 10 Mbps - 10 megabits per second
 100 Mbps - 100 megabits per second
 1000 Mbps - 1000 megabits per second (1 gigabit per second)
When you change this setting, you must click Save (at the bottom of the
page) for the change to take effect.
 Link Rate Mode – If you selected a specific Programmed Link Rate (not
Auto), you can specify one of these modes:
 Auto
 Half Duplex
 Full Duplex
 Flow Control – If you selected a specific Programmed Link Rate (not
Auto), you can enable or disable flow control.