User guide

Chapter 3 Managing Switches 83
FIGURE 3-14 Restore Dialogs – Full and Selective
3. Enter the archive file name or browse for the file. This archive file must be one
that was produced by the QuickTools Archive function. Configuration backup
files created with the Config Backup command are not compatible with the
QuickTools Restore function. The Config Backup command does not archive
the primary or secondary secrets for any security groups.
4. To restore all configuration settings, click the Full Restore tab, then click the
Restore button. To restore selected configuration settings, click the Selective
Restore tab and select one or more of the following options, then click the
Restore button:
■ Network Properties — restores all settings presented in the Network properties
dialog except the IP address. Refer to Network Properties.
■ IP Address — restores switch IP address in addition to the other network
properties.
■ Port Properties — restores all settings presented in the Port properties dialog.
Refer to Port Symbolic Name.
■ Switch Properties — restores all settings presented in the Switch properties
dialog except the domain ID. Refer to Switch Properties.
■ Domain ID — restores switch domain ID in addition to the other switch
properties.
■ Configured Zoning — restores all configured zone sets, zones, and aliases in
the switch’s zoning database excluding the active zone set.