User`s guide

A – Command Line Interface
Working with Switch Configurations
A-6 59097-00 A
0
The restore process replaces all configuration information on the switch and
afterwards the switch is automatically reset. If the restore process changes the IP
address, all management sessions are terminated. Use the Set Setup System
command to return the IP configuration to the values you want. Refer to the ”Set
Setup Command” on page A-57. To restore the switch, open a Telnet session,
then enter the Config Restore command from within an Admin session as shown:
SANbox Manager #> admin start
SANbox Manager (admin) #> config restore
The switch will be reset after restoring the configuration.
Please confirm (y/n): [n] y