Installation guide

2 – General Description

Chassis Controls and LEDs

59096-00 A 2-3

2.1.1.2

Placing the Switch in Maintenance Mode

To place the switch in maintenance mode, do the following:

1. Isolate the switch from the fabric.

2. Press and hold the Maintenance button with a pointed tool. When the

Heartbeat LED alone is illuminated, release the button.

3. After a few seconds, the POST begins illuminating all chassis LEDs.

4. When the POST is complete, the chassis LEDs extinguish leaving only the

Heartbeat LED illuminated. The Heartbeat LED illuminates continuously

while the switch is in maintenance mode.

To exit maintenance mode and return to normal operation, momentarily press and

release the Maintenance button to reset the switch.

2.1.2

Chassis LEDs

The chassis LEDs shown in Figure 2-3 provide status information about switch

operation. Refer to “Port LEDs” on page 2-6 for information about port LEDs.

Figure 2-3. Chassis LEDs

System Fault LED

(Amber)

Heartbeat LED

(Green)

Input Power LED

(Green)