Installation guide

2 – General Description
Chassis Controls and LEDs
2-2 59096-06 A
S
 Refer to the SANbox 5600 Series QuickTools Switch Management User
Guide for information about QuickTools.
 Refer to the SANbox 5600 Series Enterprise Fabric Suite 2007 User Guide
for information about using the Enterprise Fabric Suite 2007 application.
Chassis Controls and LEDs
The chassis LEDs provide information about the switch’s operational status.
These LEDs include the Input Power LED (green), Heartbeat LED (green), and
the System Fault LED (amber) as shown in Figure 2-2. Figure 2-2 identifies the
chassis LEDS on a model 5600 switch. The model 5602 switch LED arrangement
is the same. The Maintenance button is the only chassis control and is used to
reset a switch or to recover a disabled switch. To apply power to the switch, plug
the power cord into the switch AC power receptacle and into a 100– 240 VAC
power source.
Figure 2-2 Chassis LEDs and Controls
Input Power LED (Green)
The Input Power LED indicates the voltage status at the switch logic circuitry.
During normal operation, this LED illuminates to indicate that the switch logic
circuitry is receiving the proper DC voltages. When the switch is in maintenance
mode, this LED is extinguished.
L
AL AL AL
ALA
L
0
1
2
3
4
Maintenance Button
Input Power LED
(Green)
Heartbeat LED
(Green)
System Fault LED
(Amber)