Manualshelf

User`s manual

ManualsBrandsQlogic ManualsComputer equipmentSANbox-16STD Installer's/
81828384858687888990
P
r
eli
mi
n
a
ry
Switch Faceplate Display (Port Display/TL Configuration)
SANbox-8/16 Switch Management
User’s Manual 59010-06 Rev. A SANsurfer Switch Management
2-57
window by choosing View>Loop Devices. You may also enter this window as the
result of using the Previous or Next tool bar buttons while viewing other ports on
this switch.
If you attempt to enter the View>TL Configuration mode from a port that is not a
TL_port, an error message is displayed. However, if in the TL Configuration mode
on a TL_port and the Previous or Next tool bar keys are pressed, the selected port
may not be a TL_port. When this happens, the application enters the View>Loop
Devices mode for that port and will return to the View>TL Configuration mode
when a TL_port is encountered.
Main Menu Bar
There are five menus on the Main Menu Bar: File, Edit, View, Special and Help.
These menus are context-dependent. That is, they each may contain different sub-
menus depending on the window they are in.
File
The File Menu contains the same sub menus as the Fabric window (descriptions of
these sub menus can be found on page 2-20):
Edit
The Edit Menu contains the following sub menu:
• Administration — Go to “User Administration Window” on page 2-100.
View
The View Menu contains two sub menus:
• Zoom In — Same as Zoom Button.
• Zoom Out — Same as Back button.
• TL Configuration — Show the device bridging for TL ports. This menu item
is only selectable when in the Loop Devices setting.
• Loop Devices — Show a list of the devices present on the loop. This menu
item is only selectable when in the TL Configuration setting.
Special
The Special Menu contains the following sub menus:
• Reset Counts — Reset the values of all counters displayed on the statistics
portion of the faceplate display.
• Reset TL Mappings — Clear all TL mapping for this port. Other TL ports on
this switch are not affected by this command. To clear TL mapping on other
ports will require performing this command on each of those ports.
Help
The Help menu contains the following entries: