User`s manual

P
r
eli
mi
n
a
ry
Getting Started
SANbox-8/16 Switch Management
2-10 SANsurfer Switch Management 59010-06 Rev. A User’s Manual
• On the Network Configuration window, if the IP Address, Netmask Address,
and Gateway Address values were changed to reflect the current fabric,
change them back to the default values (unless permanently assigned):
IP Address: 10.0.0.1
Netmask Address: 255.0.0.0
Gateway Address: 0.0.0.0
• On the Faceplate Display window,
• Ensure that the Fabric ID is set to 1.
• Ensure that the Chassis ID is set to 0.
• Ensure that the Stage type is set to FLS- IO/Transfer.
• If the timeout values have been altered from the default settings, change
them back to the default values:
R_T_TOV: 100
E_D_TOV: 2560
R_A_TOV: 5000
• Select Special>Clear Zoning Backup to ensure that the WWN Name
Server Zoning Backup table has been cleared.
• If the fabric is using the name server WWN zoning method, it will be neces-
sary to remove the switch from the existing fabric, connect a crossover cable
from the management station to the switch, and change the name server
zoning method back to Port Groups (Topology window, Special>Select
Zoning Method).