User`s manual

P
r
eli
mi
n
a
ry
Getting Started
SANbox-8/16 Switch Management
2-8 SANsurfer Switch Management 59010-06 Rev. A User’s Manual
For a MK II switch as the Fabric Management Switch:
a. After the SANsurfer application has been loaded on the management
station, start the web browser and open the QLogic.htm file.
b. Observe that the Login dialog box shown in Table 2-1 appears.
2. If this is the first time this switch is being logged into, or if no username and
password file has been created by a super user, log in to SANsurfer using the
username and password shown in Table 2-1. Otherwise, use the username
and password assigned during a previous session. The Fabric window opens.
A Super user must set up user names, security levels, and passwords. Refer to
“User Administration Window” on page 2-100 for directions in the creation
and update of the user file.
SANsurfer stores the password file on the management station.
3. Set up or open a fabric (Set up a fabric if no fabrics have been previously
defined. Open a fabric if one is already defined.).
Table 2-1 Default Username and Password
Set- Up or Open a Fabric
NOTE:
When managing Switches in the MKII Switch family, the SANsurfer appli-
cation must be installed on the management station. For installation instruc-
tions refer to “Installing SANsurfer on a Management Station” on page 2-6.
When managing SANbox Switches, it is possible to place the application on a
local management station and run the application from there instead of using
the application that is embedded on the SANbox Switch. In this case follow
the installation instructions to place the SANsurfer application on your
management station and follow these instructions to open the application.
Password File (app.dat)
Default Username Default Password
su su
NOTE:
The very first time you run the application, you will receive an error when trying to
access the fabric file. This is normal. After a fabric is defined and saved, this error
will no longer appear at login.