User`s manual

P
r
eli
mi
n
a
ry
SANbox-8/16 Switch Management
B-2 Counter Descriptions 59010-06 Rev. A User’s Manual
In frames fcFPortC23InFrames Number of class 2 and class 3 frames received by this port.
Invalid tx words
recv
fcFPortFPortInvalidTxWords Number of invalid transmission words detected during
decoding. Decoding is from the 10-bit characters and
special K characters.
Laser Faults N/A Number of times a laser fault was detected.
LIF Flow Cntrl
Errors
N/A This is a switch internal error condition (for factory use
only).
Link failures fcFPortLinkFailures Number of optical link failures detected by this port. A link
failure is a loss of synchronization for a period of time
greater than the value of R_T_TOV or by loss of signal while
not in the offline state. A loss of signal causes the switch to
attempt to re-establish the link. If the link is not re-
established by the time specified by R_T_TOV, a link failure
is counted. A link reset is performed after a link failure.
Link reset in fcFPortLinkResetIns Number of link reset primatives received from an attached
device.
Link reset out fcFPortLinkResetOuts Number of link reset primatives sent from this port to an
attached port.
LIP AL_PD
AL_PS
N/A Number of F7, AL_PS LIPs, or AL_PD (vendor specific)
resets, performed.
LIP during Init N/A Number of times the switch received a LIP while it was
already in the initialization state.
LIP F7 AL_PS N/A This LIP is used to reinitialize the loop. An L_port, identified
by AL_PS, may have noticed a performane degradation and
is trying to restore the loop.
LIP F7F7 N/A A loop initialization primative frame used to acquire an
AL_PA.
LIP F8 AL_PS N/A This LIP denotes a loop failure detected by the L_port
identified by AL_PS.
LIP F8F7 N/A Currently not used
LIP Total
Received
total_lip_rcvd_cnt Number of loop initialization primative frames received.
Table B-1 Counter Names and Descriptions (port display window and telnet) (Continued)
Counter Name
(in port display)
Counter Name
(in telnet)
Description
(Sheet 2 of 4)