User`s manual

P
r
eli
mi
n
a
ry
show <command type>
SANbox-8/16 Switch Management
3-12 Telnet 59010-06 Rev. A User’s Manual
Restart Lost :00000000
enet_rs_errors :00000000
enet_out_of_buffers :00000000
events
This command is used for debugging. It displays the SNMP event information.
This command returns a display similar to the following:
Events:
0000003D 0000000A 00000080
0000003E 0000000A 00000080
0000003F 0000000A 00000080
00000040 0000000A 00000080
00000041 0000000A 00000080
00000042 0000000A 00000080
00000043 0000000A 00000080
00000044 0000000B 0000008E
00000045 00000002 0000047A
00000046 0000000B 00099E31
00000047 00000002 00099E40
0000002A 0000000A 00000080
0000002B 0000000A 00000080
0000002C 0000000A 00000080
0000002D 0000000A 00000080
0000002E 0000000A 00000080
0000002F 0000000A 00000080
00000030 0000000A 00000080
00000031 0000000A 00000080
00000032 0000000A 00000080
00000033 0000000A 00000080
00000034 0000000A 00000080
00000035 0000000A 00000080
00000036 0000000A 00000080
00000037 0000000A 00000080
00000038 0000000A 00000080
00000039 0000000A 00000080
0000003A 0000000A 00000080
0000003B 0000000A 00000080
0000003C 0000000A 00000080
fcport <port_num>
When specifying the port number, the allowed values range from 1 to the
maximum number of ports on the switch (8 or 16 port switches only).
The command returns a display similar to the following:
port_num :00000001
PortAdr :0010C000
LinkState :00000008
PortState :00000000