User`s manual

P
r
eli
mi
n
a
ry
show <command type>
SANbox-8/16 Switch Management
User’s Manual 59010-06 Rev. A Telnet
3-9
show <command type>
The show command provides a means for viewing the values of parameters as they
currently exist within the switch.
The available command types for the show command are (in alphabetical order):
chassis nameserver
chassis_mode network
config pagebreak
counts portrscn
ecounts portstate
events scounts
fcport snmp
links steering
loop unit
memory version
monitor
chassis
The command returns a display similar to the following:
first_port_addr :0010C000
num_of_ports :8
power supply :OK
in_order_delivery :ON
board_heat_status :OK
board_temp :30.0 c
Fan 1 Status :Absent; OK
Fan 2 Status :Absent; OK
Port Information
01 GBIC = 07, FC Address = 0010C000
02 GBIC = 00, FC Address = 0010C100
03 GBIC = 07, FC Address = 0010C200
04 GBIC = 05, FC Address = 0010C300
05 GBIC = 07, FC Address = 0010C400
06 GBIC = 02, FC Address = 0010C500
07 GBIC = 07 FC Address = 0010C600
08 GBIC = 05 FC Address = 0010C700
Where:
first_port addr = the beginning address assigned by the switch
num_of_ports = the total number of ports on this switch
powersupply = status of the power supply
in_order_delivery = ON (frames delivered in order)
OFF (frame interleaving allowed)
board_heat_status = internal temperature of the switch within limits