User`s manual

P
r
eli
mi
n
a
ry
set <command type>
SANbox-8/16 Switch Management
3-6 Telnet 59010-06 Rev. A User’s Manual
[1] - Offline
[2] - Online
[3] - In Test
Making a selection or pressing the enter key to exit this menu results in
returning to the main set config menu.
If selecting a port for the Arbitrated Loop Disable entry, the following menu
appears:
[1] - Disable
[2] - Enable
[<enter>] - To exit this menu, press the enter key
Please enter the desired value for port 0x: (Where the x indicates the actual port selected)
Making a selection or pressing the enter key to exit this menu results in
returning to the main set config menu.
If selecting a port for the MFS Mode entry, the following menu appears:
[1] - Normal
[2] - Non - Interleaved
[3] - Minimize Interleave
[4] - Frame Limit - 8
[5] - Frame Limit - 16
[6] - Frame Limit - 32
[<enter>] - To exit this menu, press the enter key
Please enter the desired value for port 0x: (Where the x indicates the actual port selected)
Making a selection or pressing the enter key to exit this menu results in
returning to the main set config menu.
config <timeout setting> <timeout value>
The Set Config command can be entered specifying a specific timeout setting and
a specific timeout value. Each of the allowable timeout settings and values are
shown below:
Ratov R_A_TOV controls the Resource_Allocation_Timeout value for all
ports on the selected chassis. The number is in ms (2000 = 2 seconds).
The default is 5000 and should not be changed without consulting
QLogic Customer Support or your authorized service provider.
Rttov R_T_TOV controls the Receiver_Transmitter_Timeout value for all
ports on the chassis. The number is in ms (2000 = 2 seconds).
The default is 100 and should not be changed without consulting
QLogic Customer Support or your authorized service provider.
Edtov E_D_TOV controls the Error_Detect_Timeout value for all ports on
the chassis. The number is in ms (2000 = 2 seconds)