User`s manual

P
r
eli
mi
n
a
ry
set <command type>
SANbox-8/16 Switch Management
User’s Manual 59010-06 Rev. A Telnet
3-5
addr <24-bit fiber channel chassis address>
Direct telnet commands to a specific switch in the fabric.
config [field]
Any changes made to the config screens will not take effect until the enter key
(with no entry) is pressed and the current command line is the telnet prompt.
If the field is included with the command, one of the following field entries must
be used, in combination with the values described later in this command descrip-
tion for the field specified:
Field: Allowable entries
lock 1, 2
admin online, offline, test
port_admin online, offline, test
rttov RT timeout value in ms
ratov RA timeout value in ms
edtob ED timeout value in ms
arb_loop enable, disable
mfs normal, non-interleaved, minimize interleave, frame limit
If no field entry is included in the command, the command returns a display
similar to the following:
[1] - Lock Chassis Number Flag (choose not locked (1) of locked (2))
[2] - Admin Chassis Mode (choose Online, Offline, or In Test)
[3] - RTTOV (DO NOT change this unless instructed by QLogic Customer Service)
[4] - RATOV (in ms)
[5] - EDTOV (in ms)
[6] - Port Admin States (see below)
[7] - Arbitrated Loop Disable (see below)
[8] - MFS Mode (see below)
[<enter>] - To exit this menu, press the enter key
Please enter the configuration parameter to set
After selecting item 6, 7, or 8 from the list above, the following is displayed:
[1] - Port 01
[2] - Port 02
[3] - Port 03
[4] - Port 04
[5] - Port 05
[6] - Port 06
[7] - Port 07
[8] - Port 08
[<enter>] - To exit this menu, press the enter key
Please enter the port number you would like to set:
If selecting a port for the Port Admin States entry, the following menu appears: