User`s manual

P
r
eli
mi
n
a
ry
Installing a New Version of SANsurfer on a SANbox Switch
SANbox-8/16 Switch Management
2-104 SANsurfer Switch Management 59010-06 Rev. A User’s Manual
Installing a New Version of SANsurfer on a SANbox Switch
Using a DOS Workstation to Install a New Version
1. Move the files containing the new version of SANsurfer from the distribution
media (CD, tape, diskette, or Internet) to the directory C:\QLOGIC on your
management station.
2. Go to the directory "C:\QLOGIC" and run the "setgui_qlogic" batch file. You
must supply the IP Address of the Switch you wish to install SANsurfer on.
For example if your Switch is at IP Address of 10.0.0.1, at the DOS
command prompt, type in "setgui_qlogic 10.0.0.1".
This batch file will execute TFTP commands that transfer each SANsurfer
file to the Switch.
3. To verify that the installation was successful, point your Web browser to the
Switch (Enter the IP Address of the Switch on the Address line of your Web
browser and press Enter). If any Java security dialog boxes appear, click on
the Grant button. You may verify that the Login dialog box contains the
newer version of SANsurfer.
Using a Unix Workstation to Install a New Version
Move the files containing the new version of SANsurfer from the distribution
media (CD, tape, diskette, or Internet) to the directory C:\QLOGIC on your
management station.
Use TFTP to put the following files on the Switch. Be sure to select Binary when
transferring the files.
put Sun.htm webgui/Sun.htm
put Sun.htm webgui/index.htm
put SunNoplugin.htm webgui/SunNoplugin.htm
put Sun.jar webgui/Sun.jar
Contact QLogic Customer Support for details.
NOTE:
TFTP is required to upgrade SANsurfer on a Switch,