User`s manual

Preliminary
Battery (Repair Depot Only)
SANbox-16STD Fibre Channel Switch
Installer’s/User’s Manual 59012-03 Rev. A Removal/Replacement Procedures 4-5
2. Slide the GBIC into the port opening (the spring-loaded door will open as
you push the GBIC in). If you can only slide the GBIC in about an inch (2.5
cm) before it stops, you have the Keyway in the wrong position; flip the
GBIC over and try it again.
3. Push the GBIC in until the GBIC Latches snap into place. If you have a
GBIC that has bail-operated latches, make sure that the bail is rotated to the
latched position. This allows the latches to latch (refer to Figure 4-4).
4. Cable the port. Refer to Section 2 Installation for cabling instructions.
Battery (Repair Depot Only)
The battery powers non-volatile memory used to store the Switch configuration.
The battery has a service life of 10 years.
WARNING:
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the manufacturer.
Dispose of the used battery according to the manufacturer’s instructions.
WARNUNG:
Bei unsachgemäß ausgetauschter Batterie besteht Explosionsgefahr.
Die Batterie nur mit der gleichen Batterie oder mit einem äquivalenten, vom
Hersteller empfohlenen Batterietyp ersetzen.
Die gebrauchte Batterie gemäß den Herstelleranweisungen entsorgen.
AVERTISSEMENT:
Danger d’explosion si le remplacement de la pile est incorrect.
Ne remplacer que par une pile de type identique ou équivalent recommandé par le
fabricant.
Jeter la pile usagée en observant les instructions du fabricant.