User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index
Preliminary
GBIC
SANbox-16STD Fibre Channel Switch
4-4 Removal/Replacement Procedures 59012-03 Rev. A Installer’s/User’s Manual
To remove GBICs that have bail-operated latches, as shown in Figure 4-4,
use your finger-tip to rotate the bail outward, then pull on the bail to remove
the GBIC.
Figure 4-4 Removing GBICs that have bail-operated latches
Replacement
GBICs may be removed and replaced with the Switch power on without disrupting
traffic on other ports.
1. Orient the GBIC as shown in Figure 4-5. The Keyway is on the bottom (as
shown) for the top row of ports and on the top for the bottom row of ports.
Figure 4-5 Replacing GBICs
Latch
Keyway
Bail
Connector
GBIC
Connector
Port
Connector
Keyway
Latch