User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index
Preliminary
SANbox-16STD Fibre Channel Switch
iv
59012-03 Rev. A Installer’s/User’s Manual
Power Switch 1-19
Test Mode Switch 1-19
Front Panel LEDs 1-20
Heartbeat LED (Yellow) 1-20
Switch Logic Power Good LED (Green) 1-20
Fan Fail LED (RED) 1-20
Over Temperature LED (Red) 1-20
Logged-In LED (Green) 1-21
Traffic LED (Yellow) 1-21
AC Input Power Connector and Fuses 1-22
Switch Management Connector 1-22
2
Installation
Introduction 2-1
Unpack 2-2
Place or Mount the Equipment 2-2
Shelf Mount 2-2
Rack Mount 2-3
Apply the IEC Class 1 Laser Information Label (If the installation is in Europe) 2-5
Install GBICs 2-6
Connect to AC Power 2-6
Switch Logic Power Good LED 2-8
Check the Power-On-Self-Test (POST) Results 2-8
Cable Fibre Channel Devices to the Switch 2-9
Public Devices 2-9
Private Devices 2-10
Mixing Public and Private Devices on the Same Loop. 2-10
Switch Ports 2-10
Tuning 2-10
Distance 2-11
Port Buffer Credits 2-11
Hot-Pluggable 2-12
Incorrect Cabling 2-12
Connections 2-12
Examples 2-13
Configure the Chassis 2-18
Configure the Ports 2-19
Fabric Ports 2-19
SL_Ports 2-19
TL_Ports 2-20
T_Ports 2-20
Tuning Ports for Multi-Frame Sequences 2-21