User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index
Preliminary
SANbox-16STD Fibre Channel Switch Specifications
SANbox-16STD Fibre Channel Switch
A-8 Reference Information 59012-03 Rev. A Installer’s/User’s Manual
Figure A-1 SANbox-16STD Switch Dimensions in Millimeters (Inches)
444.5 (17.5")
85.34 (3.36")
17.78 (.7")
24
6
8
10
12
14
16
1
3
5
7
9
11
13
15
Rx
Tx
RxTx
422.2
(16.625”)